Controlled return
Reconditioned product. Inspected, cleaned and repaired (if necessary) by a technician/engineer. Warranty 2 years and supplied with all the accessories essential for its operation. The package leaflet or packaging may be missing.
presentation
Heatit's Z-TRM3fx is a wall thermostat that allows you to control your electric heating, underfloor heating (for example via the Heatit Z-Water), etc.
It is equipped with a Z-Wave+ chip that allows it to be connected to home automation systems (FIBARO, eedomus, Vera, Zipato, etc.)
It has a very clear display that indicates the set temperature or the measured temperature. The screen allows you to navigate through the menus to configure the many options available thanks to three touch buttons.
This thermostat plugs into the existing heating to switch the heating to ON / OFF. The set temperature can be changed directly via the screen or through a compatible home automation controller.
To measure the temperature, the thermostat has a built-in probe, but also offers connectors to connect a temperature sensor to the ground or an external temperature probe.
It is possible to memorize two different instructions thanks to the Comfort and Eco modes:
- Comfort: Is used for normal use. Example: 22 ° C.
- Eco: Is a withdrawal mode that you can use if the thermostat is installed in a room or house that is rarely used. ECO mode can also be activated by the pilot wire if it is connected. Example: 15 ° C.
The Z-TRM3fx is an evolution of the Heatit and Z-TRM2fx. For example, it has the following improvements: SmartStart, S2 Framework, Air Update (OTA), Multi Channel Associations support, etc.
duties
- Z-Wave thermostat for electric heating, underfloor heating, etc.
- Possibility to adjust the temperature up to + or - 3 ° C in case of bias.
- Backlit display with brightness adjustment
- Possibility to completely turn off the display in standby mode (use in a room for example)
- Parental lock
- Power consumption tracking
- Shows the status of the relay
- Ambient probe
- Support du Multi Channel Associations
- Support du SmartStart
- Firmware update by air (OTA)
- Support du Framework S2
- External temperature sensor provided (3m)
- Temperature limiter
- Z-Wave 500 series chip
- Weekly program / withdrawal temperature via a home automation box
- ECO / Comfort Modes
- Can be used with different NTC sensors
- 5 associations
TECHNICAL SPECIFICATIONS
- Display: 3x 7-Seg 13.2mm white LED screen
- Power supply: 230V - 50/60 Hz
- Maximum load: 16A (resistive)
- Consumption: <2.0W
- Temperature range: + 5 °C / + 40 °C
- Hysteresis: 0.3°C to 3.0°C
- IP Class: IP21
- Color: White RAL 9003
- Comes with ground temperature sensor, Art no. 5430107
