PRESENTATION
The thermostat Z-Wave Heatit is a mural thermostat allowing control of your electric heating, underfloor heating, etc.
The thermostat Heatit is equipped with a Z-Wave chip allowing it to be connected with domotic systems (Fibaro, eedomus, Vera, Zipato, etc.)
It has a very clear display indicating the setpoint temperature. The screen allows to navigate in the menus so as to configure the many available options with three touch buttons.
This thermostat is wired to the existing heating to switch the heating on and off. The setpoint temperature can be modified directly via the screen or by a compatible domotic controller.
To mesure the temperature, the thermostat has an integrated sensor, and proposes also connectors for linking a temperature sensor to the ground or an outside temperature sensor.
It is possible to memorise two different instructions thanks to the Comfort et Eco modes :
- Comfort : For a normal use. Example : 22 ° C.
- Eco : Withdrawal mode you can use if the thermostat is installed in a room or a house that is rarely used. The ECO mode can also be activated if the pilot wire is connected. Example : 15 ° C.
FUNCTIONS
- Z-Wave thermostat for electric heating, underfloor heating, etc.
- Possibility to set the temperature to + or - 4°C in case of bias.
- Hysteresis setting
- Backlit screen with brightness control
- Possibility to switch off the display in standby mode (use in a bedroom for example)
- Parental lock
- Indoor sensor
- Outdoor temperature sensor provided (3m)
- Temperature limiter
- Power regulator
- Series 500 Z-Wave chip
- Weekly program / shrinkage temperature via a domotic box
- ECO / Comfort modes
- Can be used with different NTC captors
- 8 scenarios
TECHNICAL CARACTERISTICS
- Display : White LED 3x 7-Seg 13.2mm screen
- Power : 230V - 50/60 Hz
- Maximum load : 16A (resistive)
- Temperature range : + 5 °C / + 40 °C
- Displayed temperature : -30 °C .... 60 °C
- Temperature limit : 5 °C ... 35 °C
- Regulator minimum limit : 0 (0 ... 9)
- Instruction CO mode : 21 ° C (5 °C ... 40 °C)
- Instruction ECO mode : 18 ° C (5 ° C ... 40 ° C)
- Power regulator : P02 (P00 ... P10) 30-minute cycle
- Shrinkage temperature activation: Z-Wave user interface / Pilot wire
- IP Class : IP21
- Colour : RAL 9003 White
- Certifications : CE - FIMKO - Z-Wave Plus
