OMNIO - Push-button interface 2-channels TST230/10

Presentation

The Omnio flush mounted push-button interface 2-channels TST230/10 is a binary input device to integrate wired push-buttons, switches and sensors into the Omnio radio system. Two potential free closing contacts may be connected to its inputs.

Depending on the chosen type of evaluation (rocker, push-button, time switch or weather station) the push-button interface transmits, repeats and additionally multiplies the matching radio telegram by actuating the closing contacts IN1 and IN2.

Apart from that Omnio radio transmitters can be programmed and their radio telegram can be multiplied via split function. Bidirectional communication, EEP F6-02- 01, ARCO ready (AWAG Remote Commissioning). In addition, this actuator can be used as repeater in case of range issues. Suitable for flush mounted sockets.

Function

• 2 potential free inputs for wired sensors 
• Input evaluation as rocker, push-button, time switch or weather station 
• 1…5 retransmissions 
• Clone function 
• Send on chip ID or Base ID 
• Split function for Omnio radio transmitters 
• Repeater function 
• EnOcean Equipment Profile (EEP) F6-02-01 
• ARCO ready (AWAG Remote Commissioning)

Technical specification

• Voltage supply : 110-240 V~ 50/60 Hz
• Standby power consumption : 0.6 W
• Hardware protection (automatic circuit breaker / fuse) : 13 A
• Input : Two isolated contacts between IN1 resp. IN2 and OUT
• Screw terminals : 4 mm²
• Protection class : IP20
• Overvoltage protection : ✓
• Permanent short circuit proof (control unit) : ✓
• Technology : EnOcean 868 MHz 
• Radio module : EnOcean TCM320 bidirectional
• EnOcean Equipment Profile (EEP) : F6-02-01
• Environment : -20 … +40 °C / 5 ... 90 % rH non condensing
• Housing : Lexan, ø 51 x 25 mm
• Weight : 45 g
• EC-Directives : 2006/95/EC, 2004/108/EC
• Standards : EN 606692, EN 61000, EN 62493